hi i have just bought a new digital mixer the behringer ddx3216 , i would like to be able to connect it up to sonar producer and control it from my desk .
i have a variaty of connections on the back of the desk midi in,thru,out smpte, rs232, i also have connections on my sound card wordclock in and out ,coaxial s/pdif in and out and midi in and out then on the other breakout cable from my sound card i have 8 audio ins and 8 audio outs plus 2 mic inputs ?
can you help as to which of these i should use and if its possible to control the sliders ect ect from either computer to desk or desk to computer

many thanks for reading

What is the break out box you have?

I think you'd get quicker results in the cakewalk forums:

http://forum.cakewalk.com/tt.asp?forumid=5
_________________
Recording Studio Suntans

Quote:

What is the break out box you have?

its not a box they are cables that are connected to my sound card which is the delta 1010lt

If the mixer sends midi signal to interpret the fader movements you should be able to hook up the midi out to the delta's midi cable. You'll have to set up the control surface in sonar with it's generic contol surface interface sequence but they might have templates at the cakewlak forum (but I doubt they'd have something for that model of mixer... might be wrong) if not I'm sure you could somebody there that could help you through the generic setup. That's all if your mixer sends midi code for the fader movements ect. not familier with that model.
_________________
That is not dead which can not die and with strange eons even death may die..... H.P. Lovecraft